Struct opentitanlib::transport::hyperdebug::spi::HyperdebugSpiTarget

pub struct HyperdebugSpiTarget { /* private fields */ }

Implementations

impl HyperdebugSpiTarget

pub fn open( inner: &Rc<Inner>, spi_interface: &BulkInterface, enable_cmd: u8, idx: u8, supports_tpm_poll: bool ) -> Result<Self>

Trait Implementations

impl Target for HyperdebugSpiTarget

fn get_transfer_mode(&self) -> Result<TransferMode>

Gets the current SPI transfer mode.

fn set_transfer_mode(&self, _mode: TransferMode) -> Result<()>

Sets the current SPI transfer mode.

fn get_bits_per_word(&self) -> Result<u32>

Gets the current number of bits per word.

fn set_bits_per_word(&self, bits_per_word: u32) -> Result<()>

Sets the current number of bits per word.

fn get_max_speed(&self) -> Result<u32>

Gets the maximum allowed speed of the SPI bus.

fn set_max_speed(&self, frequency: u32) -> Result<()>

Sets the maximum allowed speed of the SPI bus.

fn supports_bidirectional_transfer(&self) -> Result<bool>

Indicates whether Transfer::Both() is supported.

fn supports_tpm_poll(&self) -> Result<bool>

Indicates whether Transfer::TpmPoll is supported.

fn set_pins( &self, serial_clock: Option<&Rc<dyn GpioPin>>, host_out_device_in: Option<&Rc<dyn GpioPin>>, host_in_device_out: Option<&Rc<dyn GpioPin>>, chip_select: Option<&Rc<dyn GpioPin>>, gsc_ready: Option<&Rc<dyn GpioPin>> ) -> Result<()>

Sets which pins should be used for SPI communication. None value means use the same pin as previously, or the implementation default if never before specified. This call is not supported by most backend transports, and ones that do support it may still have restrictions on which set of pins can be used in which roles.

fn get_max_transfer_count(&self) -> Result<usize>

Returns the maximum number of transfers allowed in a single transaction.

fn get_max_transfer_sizes(&self) -> Result<MaxSizes>

Maximum Read and Write data size for run_transaction().

fn get_flashrom_programmer(&self) -> Result<String>

Returns "raiden_debug_spi:serial=XXX" or similar string usable for passing via -p argument to flashrom, in order for it to connect to this SPI port instance.

fn run_transaction(&self, transaction: &mut [Transfer<'_, '_>]) -> Result<()>

Runs a SPI transaction composed from the slice of Transfer objects. Will assert the CS for the duration of the entire transactions.

fn run_eeprom_transactions( &self, transactions: &mut [Transaction<'_, '_>] ) -> Result<()>

Runs a number of EEPROM/FLASH protocol SPI transactions. Will assert and deassert CS for each transaction.

fn assert_cs(self: Rc<Self>) -> Result<AssertChipSelect>

Assert the CS signal. Uses reference counting, will be deasserted when each and every returned AssertChipSelect object have gone out of scope.

fn set_voltage(&self, _voltage: Voltage) -> Result<()>

fn get_eeprom_max_transfer_sizes(&self) -> Result<MaxSizes>

Maximum payload size of Read and Write elements for run_eeprom_transactions().

impl TargetChipDeassert for HyperdebugSpiTarget

fn deassert_cs(&self)