Referring to the Comportable guideline for peripheral device functionality, the module uart has the following hardware interfaces defined
- Primary Clock:
clk_i
- Other Clocks: none
- Bus Device Interfaces (TL-UL):
tl
- Bus Host Interfaces (TL-UL): none
| Pin name | Direction | Description |
|---|
| rx | input | Serial receive bit |
| tx | output | Serial transmit bit |
| Port Name | Package::Struct | Type | Act | Width | Description |
|---|
| tl | tlul_pkg::tl | req_rsp | rsp | 1 | |
| Interrupt Name | Type | Description |
|---|
| tx_watermark | Status | raised if the transmit FIFO is past the high-water mark. |
| rx_watermark | Status | raised if the receive FIFO is past the high-water mark. |
| tx_done | Event | raised if the transmit FIFO has emptied and no transmit is ongoing. |
| rx_overflow | Event | raised if the receive FIFO has overflowed. |
| rx_frame_err | Event | raised if a framing error has been detected on receive. |
| rx_break_err | Event | raised if break condition has been detected on receive. |
| rx_timeout | Event | raised if RX FIFO has characters remaining in the FIFO without being retrieved for the programmed time period. |
| rx_parity_err | Event | raised if the receiver has detected a parity error. |
| tx_empty | Status | raised if the transmit FIFO is empty. |
| Alert Name | Description |
|---|
| fatal_fault | This fatal alert is triggered when a fatal TL-UL bus integrity fault is detected. |
| Countermeasure ID | Description |
|---|
| UART.BUS.INTEGRITY | End-to-end bus integrity scheme. |